Lightwave Community at SimplyLightwave

Page 3 of 3

Show 40 post(s) from this thread on one page

Lightwave Community at SimplyLightwave (http://simplylightwave.com/forum//index.php)

- W.I.P (http://simplylightwave.com/forum//forumdisplay.php?f=11)

- - Rail Grinder (http://simplylightwave.com/forum//showthread.php?t=4370)

Fallenswordsman

01-02-2006 07:44 AM

Looking excellent there, Odeone - may I ask a quick question though? How have you made the lights look flush up against the curved surface of the front of the Rail Grinder? Is there any special magic technique that I'm missing, or do you do it like I would and just eyeball it?

odeone

14-02-2006 06:20 AM

1 Attachment(s)

Quote:

How have you made the lights look flush up against the curved surface of the front of the Rail Grinder? Is there any special magic technique that I'm missing, or do you do it like I would and just eyeball it?

Sorry for the late reply. I bend the plate to match the curved surface. No magic required. Screenshot below for reference.

Cheers...

odeone

25-02-2006 03:03 AM

1 Attachment(s)

Started on the pantograph, this is the progress so far...

Cheers...

JasC33

25-02-2006 03:44 AM

Wow.. That is looking awesome. Fantastic looking detail.:eek:

odeone

05-03-2006 01:47 PM

1 Attachment(s)

Thanks JasC33...

Pantograph finally done. On to the inside to build some drivers controls. Not sure after that...

priimate

09-03-2006 10:32 PM

Hey Bud! This is lookin' brilliant - you'll have to do a little engineer to drive this dealie [and maybe a fat controller too!].

Cheers! priimate.

All times are GMT. The time now is 04:57 PM.

Page 3 of 3

Show 40 post(s) from this thread on one page