Spartan
 

This is my NEW model of a Spartan from the bungie game halo, i say A becasue there was a total of about 32ish of these to begin with but this is my second try at this model so any comment would be nice.

its cool for now :) keep going !

cool i like the shape of the guard bits but the visor looks a bit fat however

Looking good
Blackclaw

yeah your right i do need to do some tweeking on the visor

nice start!

just a few things i noticed about the mc




Visor looks awsome

ill get right on it

about the curyness im fixing that but about the face plate i am working of a side view of the helmet i snached from the halo 2 video so as far as i know i have it in the right place but thanks for your input

here are my up date...i dont no if you can see much differnet but i did change the curve of the faceplate

Now that i think about it, i don't think there is any verticle bending, just horizontal across the plate. What is your method of modeling? I started to make him too and could figure out how to start.

i am making him literaly point by point...i have a crude side view of the MC and from there i just made points along the edge of his face plate and then copy and pasted them so the next set looked ok then i selected four polygons and hit "P" and i did it over and over and over again

here be an update...

there i had did some work on the back and i did some playin around with the reflection on his visor

i dont know if youll be able to see this short vid of the helmet spinning cuz i thnik its a bit too big but ill try

darn it didnt work...ill try to fiibd another way to post that

here is iw with textures