hollo
 

i can't make the grass or tree flow by the wind.. help me

Ok, really it depends on shot to shot. You need to decide what your shot is going to be. Then you can go about getting it. Ok for a really close up shot. Say like blizzard.. diablo.. the crow and grass.. Ok,, then i would suggest either enomorphs. Or bones and dynamics. You can try it with one grass,, then clone it,,, using various techniques.

Ok for a quick grass,, you can try saslite. The coming in either x y or z will help you get a messy wind blowing sort of look,, if the shot is a far one.

The same goes for trees. For a close up shot, a lot of attention to detail is needed so you really need to think it up, say a storyboard of how the shot is going to be done helps loads.. even if its only 1 sec animation.

Oh ya check out the tutorial here about grass and trees,, and a little animation.
http://www.simplylightwave.com/movie...tml?tut_id=505

Kumar Kumar
 

It dosnt get any better than Kumars break down....;)