Moenzi, thanks for the comments. I know that the knobs aren't finished yet. I've still got some texturing to do. but this was the state is was in last night (started at around 10am, finished at around 2am - worked solid pretty much all day).
I managed to eventually get the signature from the JCM 800 2230 reissue manual on Marshall's website. Just a little touchup in Photoshup, and it looks the biz.
I've currently now got it to the stage where the back panel is just about textured, and all the modelling is done there too. I need to model the valves and caps sitting on top of the amp, and also texture the mesh panel that sits in front of them - that and the feet should finish this off (I'm hoping to pretty much have this complete by the end of today).
Once that's done, I can work on the cabs...
There is one glaring problem that I think I've stumbled upon, and that is the front panel of this is worked after the JCM800 2230 Reissue amps. However, the reference shot that I've used for the rear panel is from an original JCM800 50W Lead, so the model is slightly inaccurate. Also, the shot I have of the rear panel is rather poor, so I've not managed to get all the detail in there, but it looks respectable enough for now...
|