Lightwave Community at SimplyLightwave - View Single Post

Simmo1111 · 03-04-2004, 11:56 PM

I am currently working through Dan Ablans' Inside Lightwave 7 book and have reached a point where i am modelling the hull of a rowing boat. After drawing my first spline i am then instructed to select the clone tool and enter the offset values as pictured in the book..This should obviously create copies of my original spline in the positions dictated by the offset ( 4 copies selected)..I enter all the required parameters and hit "enter" and according to the book i will see my cloned splines....I hit "enter" and nothing happens ??? Am i missing something..

Cheers
D

03-04-2004, 11:56 PM	#1
Simmo1111 Registered Member Join Date: Mar 2004 Posts: 5	Use of the clone tool I am currently working through Dan Ablans' Inside Lightwave 7 book and have reached a point where i am modelling the hull of a rowing boat. After drawing my first spline i am then instructed to select the clone tool and enter the offset values as pictured in the book..This should obviously create copies of my original spline in the positions dictated by the offset ( 4 copies selected)..I enter all the required parameters and hit "enter" and according to the book i will see my cloned splines....I hit "enter" and nothing happens ??? Am i missing something.. Cheers D