Lightwave Community at SimplyLightwave - View Single Post

keef · 26-04-2004, 07:10 PM

Hi Buddies

This is my problem: I create a cone (for example) in Modeler – then rotate it say 30° on the ‘y’ axis. When the cone is sent to Layout the axis of the cone is perpendicular and not through the natural axis of the cone. Is it possible to change this?????

I am giving this as an example – as the object I plan to construct in Modeler is much more complex and must rotate – on its natural axis.

I hope that all makes sense….

thanks

Keith

PS I tried to attach a jpeg but I think my firewall stops it being sent!!!!

26-04-2004, 07:10 PM	#1
keef Full Access Member Join Date: Feb 2003 Location: Scotland Posts: 41	Offsetting axis of model Hi Buddies This is my problem: I create a cone (for example) in Modeler – then rotate it say 30° on the ‘y’ axis. When the cone is sent to Layout the axis of the cone is perpendicular and not through the natural axis of the cone. Is it possible to change this????? I am giving this as an example – as the object I plan to construct in Modeler is much more complex and must rotate – on its natural axis. I hope that all makes sense…. thanks Keith PS I tried to attach a jpeg but I think my firewall stops it being sent!!!!