[MBStudios]

EDIT:

Ok I descided to come back and edit this post. I have run into a snag and I am finding it will probably be more work to correct than its worth.

I had started on the rear section of Car and it was looking good until I was moving forward to conect it to the front section and thats when I begin noticing some major problems with alighnment in so many areas that I am trying to descide should I scrap the front and take the back and move it forward or should I scrap the back.

Oh well, I am wondering now if I will ever get a car completed.

I realized what my problem was or is. It is the alignment of backdrops. I was only able to find a Side view and front view and rear view Photos of the car. However I found a Top view of the Car but it was a photo of a Model.

Thinking I could use it to at least get a general idea of the shape or placement was ok in the begining .. at first it wasnt a problem, but I think I may have used it to often as though it was accurate forgetting that it was not hince my back section does not want to line up with my front.

I know now I could have avoided this or at least determined this much earlier if I had created a complete spline cage of the car ooops my bad yes I know I made big boo boo!!!!

Impatience did this one in.... However I am willing to start from scratch if I could just find some blueprints/ 3 view pics that in fact line up as I want to really do this car.

I guess I could model an earlier model of the Stang such as the 99 model I think there are Blueprints of it, or I could go even earlier as I happen to have accurate prints of the earlier stang.

I dont know guys kind of down in the dumps on this one!!!

ANyone know or have blueprints of this car?

MBStudios

MBStudios