Lightwave Community at SimplyLightwave - View Single Post

greeneggsandsam · 13-02-2005, 05:54 PM

Working on crossed drilled rotor for added detail to rims. Using boolean to drill holes through rotor. On first attempt I had all the holes set up and when I went to Boolean them onto the rotor, my PC came to a grinding halt. For my second attempt I tried to drill the holes one row at a time, but when I tried the second row, PC LOCK UP!!! (very bad). Maybe I am going about this the hard way. Is there an easier way, or should I just UV map an image to the rotor? (Just thought of that as I was submitting this post) :o :o

Thanks

13-02-2005, 05:54 PM	#1
greeneggsandsam Registered Member Join Date: Dec 2004 Location: Kelowna, British Columbia, Canada Posts: 15	Cross Drilled Rotor Working on crossed drilled rotor for added detail to rims. Using boolean to drill holes through rotor. On first attempt I had all the holes set up and when I went to Boolean them onto the rotor, my PC came to a grinding halt. For my second attempt I tried to drill the holes one row at a time, but when I tried the second row, PC LOCK UP!!! (very bad). Maybe I am going about this the hard way. Is there an easier way, or should I just UV map an image to the rotor? (Just thought of that as I was submitting this post) :o :o Thanks __________________ Life should NOT be a journey to the grave with the intention of arriving safely in an attractive and well-preserved body, but rather to skid in sideways, Vodka (Rum)in one hand - The Blender in the other, body thoroughly used up, totally worn out and screaming "WOO HOO - What a Ride!"