Lightwave Community at SimplyLightwave - View Single Post

R4s1n · 01-04-2005, 07:26 PM

Alright i just tried it out with a box and i found a rather long method. Go into 3d Viewport and Select all the polygons that you see (One by One

). That way it only select the top layer even though there are actually two of them. Make sure that you only use the 3d Viewport and not the other ones.

My 2 cents.

If you have a high poly model then that would really suck.

01-04-2005, 07:26 PM	#2
R4s1n Full Access Member Join Date: Aug 2003 Location: Manchester, PA Posts: 1,319	Alright i just tried it out with a box and i found a rather long method. Go into 3d Viewport and Select all the polygons that you see (One by One ). That way it only select the top layer even though there are actually two of them. Make sure that you only use the 3d Viewport and not the other ones. My 2 cents. If you have a high poly model then that would really suck. __________________ Johnny was a chemist's son, but Johnny is no more. What Johnny thought was H2O was H2SO4.