Lightwave Community at SimplyLightwave - View Single Post

Nikon44 · 03-08-2005, 06:00 PM

Ok, I have a piece I am working on where i have smoth shifted a setion. But the only problem is that it rounds all outlying parts. I need the section to be square as it is a light that is resesed in a bumper, any ideas on how to do this?

Thanks
Sean

03-08-2005, 06:00 PM	#1
Nikon44 Registered Member Join Date: Feb 2005 Posts: 9	Square up Ok, I have a piece I am working on where i have smoth shifted a setion. But the only problem is that it rounds all outlying parts. I need the section to be square as it is a light that is resesed in a bumper, any ideas on how to do this? Thanks Sean