Originally posted by juney
ohh a vid tut, will check it out
a short question, how do i change the tip of a cone to be rounded in subpatch mode
|
You should have triangles at the tip of the cone, which will subpatch. If you have an extra row of polys or a cut near the tip, it will sharpen the point so, if you want to keep it rounded,. make sure the point is not too close to the cut. You can also select pairs of trianges and use Shift+Z to merge the tris into a quad which will subpatch cleaner. Howerver, I would delete the end polys and rebuild it by extending the points and stretching them together,.. then merge the points, and then merge tris.