Lightwave Community at SimplyLightwave - View Single Post

Cchristensen · 03-11-2005, 09:49 PM

I have done single page turns but now that I think about it, this could probably work for lots of pages as well.

I made a model of a book open in the middle. Then I made (on a new layer) a single page sticking straight up. Then I made 2 morph maps - 1 of the page turned to the left and the other turned to the right. In layout you just add morph mixer and use the 2 sliders to make the pages turn. For lots of pages you could just clone your page and shift the keyframes a little for some offset.

03-11-2005, 09:49 PM	#2
Cchristensen Full Access Member Join Date: Jan 2003 Location: Wisconsin Posts: 250	I have done single page turns but now that I think about it, this could probably work for lots of pages as well. I made a model of a book open in the middle. Then I made (on a new layer) a single page sticking straight up. Then I made 2 morph maps - 1 of the page turned to the left and the other turned to the right. In layout you just add morph mixer and use the 2 sliders to make the pages turn. For lots of pages you could just clone your page and shift the keyframes a little for some offset.