Lightwave Community at SimplyLightwave - View Single Post

imazip · 20-03-2003, 01:17 PM

Thanks for the tips. I'll give them a try. As I'm still getting familiar with the modeling tools which tools would you use to add segments. (cloning? s-shifting? julienne?) Would you use the bend tool then on the cylinder, lathe tool?

I'll start experimenting. I need the practice. Thanks again!

20-03-2003, 01:17 PM	#4
imazip Full Access Member Join Date: Jan 2003 Location: Washington, D.C. Posts: 9	Thanks for the tips. I'll give them a try. As I'm still getting familiar with the modeling tools which tools would you use to add segments. (cloning? s-shifting? julienne?) Would you use the bend tool then on the cylinder, lathe tool? I'll start experimenting. I need the practice. Thanks again!