Lightwave Community at SimplyLightwave - View Single Post - Show assigned points of selected weight map

NoStr0m0 · 03-05-2006, 04:45 PM

I believe there is something under View - Selection- More - Maps - Select by Map Influence
which works on all types of maps(UV, Weight).
If you want to select all the points affected by that map just set the Selection Mode to Range and type in 0 and 1.
Be careful though. There are some cases, and I found this when I mirrored some weight maps, when after the operation was done, all right side points had all the weight maps assigned to them(like fingers had spine weight maps, foot maps), just at a value of 0. So you might consider not beginning at 0, but a little higher value.

Cheers! :beer:

03-05-2006, 04:45 PM	#2
NoStr0m0 Registered Member Join Date: Jan 2005 Location: Somewhere... in 3D space Posts: 153	I believe there is something under View - Selection- More - Maps - Select by Map Influence which works on all types of maps(UV, Weight). If you want to select all the points affected by that map just set the Selection Mode to Range and type in 0 and 1. Be careful though. There are some cases, and I found this when I mirrored some weight maps, when after the operation was done, all right side points had all the weight maps assigned to them(like fingers had spine weight maps, foot maps), just at a value of 0. So you might consider not beginning at 0, but a little higher value. Cheers! :beer: __________________ " ...'till the world burned!"