Thanks Fallenswordsman for you notice of my work. I do have some questions for you if you dont mind. You notice the saslite grass I made It is really colored bright yellow straw colored but in the renders it appers almost black what gives? Also the stage I made for the dino is a large box subdivided a few times and subpatched with the top deleated and polys flipped to the inside OK. I selected the floor on this box in modeler and applied a new surface and applied saslite but I got a message that there were too many ploys to use saslite. So I went back into modeler and instead selected several small patches at random on the floor and copied them to a new layer and applied a new surface. Then moved to layout and applied the saslite to these small groups of polys but I still got the same message. I know there cant be that many ploys maybe a few hundred. I am thinking that my mistake is that both the box stage and the saslite polys are all at y=0, I am thinkibng that saslite is confused by this and sees them all as one grouip. I havent tried it yet but I am thinkuing that I should move the small groups up a little in Y and stretch them a little so they dont match the floor anymore. Am I on the right track here. Thanks for your help. Steve:bandit:
|