Lightwave Community at SimplyLightwave - View Single Post

grim_d · 01-01-2008, 02:17 PM

I made the title broad as i will probably posts a few questions here over time, heh.

anyway, i just started part 3 of the video tutorial for the mclaren, where you start spline patching.

To start i could not get it to patch corectly, so after much fiddling i eventually got there, however, i had to change the perpindicular and parralel values around for nearly every section, and most of the polys were upsidedown.

anybody have any idea why this might of happened?

01-01-2008, 02:17 PM	#1
grim_d Full Access Member Join Date: Dec 2007 Posts: 6	mclaren questions I made the title broad as i will probably posts a few questions here over time, heh. anyway, i just started part 3 of the video tutorial for the mclaren, where you start spline patching. To start i could not get it to patch corectly, so after much fiddling i eventually got there, however, i had to change the perpindicular and parralel values around for nearly every section, and most of the polys were upsidedown. anybody have any idea why this might of happened?