Lightwave Community at SimplyLightwave - View Single Post - post-epsn

carnaby · 24-07-2010, 08:40 AM

Thanks rwhunt99, not so sure about the version of epsn that I'm using but as regards Lightwave its version 9.The screen shot looks similiar to the version I've got, I'll check if there is a newer version which would improve things, the request is pretty simply but as you can see from screen shots the result is way off, tried reducing points to 'rough' in epsn andy even importing each element one by one still no go, I've now moved onto other areas of modeler whilst I await a solution, which already is resulting in a new posting, 'aligning objects to either points or surfaces'
Mark has given some directions which I'm looking into, its a long road this but here for the long haul.

24-07-2010, 08:40 AM	#10
carnaby Registered Member Join Date: Jun 2010 Location: london Posts: 7	post-epsn Thanks rwhunt99, not so sure about the version of epsn that I'm using but as regards Lightwave its version 9.The screen shot looks similiar to the version I've got, I'll check if there is a newer version which would improve things, the request is pretty simply but as you can see from screen shots the result is way off, tried reducing points to 'rough' in epsn andy even importing each element one by one still no go, I've now moved onto other areas of modeler whilst I await a solution, which already is resulting in a new posting, 'aligning objects to either points or surfaces' Mark has given some directions which I'm looking into, its a long road this but here for the long haul.