Lightwave Community at SimplyLightwave - View Single Post - fao: David Mitchell Home Interior Tutorial

peepo · 07-01-2011, 11:45 AM

another problem within this tutorial - something Im doing wrong Im sure.

David goes into layout - I was hoping on the same basic level of instruction as in modeller, but we are into Lscript straight away.

I tried following the instructions in the tutorial to set up a script to generate a 4 point lighting rig, but when I try to run the lscript, I get "In generic, line 10, found 'S' parse error"

Line 10 in the script is this:

CommandInput ("AddLight "Spotlight" "key"");

07-01-2011, 11:45 AM	#2
peepo Full Access Member Join Date: Nov 2010 Posts: 30	another problem within this tutorial - something Im doing wrong Im sure. David goes into layout - I was hoping on the same basic level of instruction as in modeller, but we are into Lscript straight away. I tried following the instructions in the tutorial to set up a script to generate a 4 point lighting rig, but when I try to run the lscript, I get "In generic, line 10, found 'S' parse error" Line 10 in the script is this: CommandInput ("AddLight "Spotlight" "key"");