Lightwave Community at SimplyLightwave - View Single Post

rich_is_bored · 30-04-2003, 05:24 AM

Looks pretty good to me.

I think the only thing that might need a little work is the surface of the shaft that holds the needle.

I figure that wouldn't be very reflective. I'm thinking just plain dull steel would work better.

You might want to put a very subtle bevel on the edge of that shaft aswell. Its very rare to find a true sharp edge like that in the world.

30-04-2003, 05:24 AM	#2
rich_is_bored Full Access Member Join Date: Jan 2003 Posts: 174	Looks pretty good to me. I think the only thing that might need a little work is the surface of the shaft that holds the needle. I figure that wouldn't be very reflective. I'm thinking just plain dull steel would work better. You might want to put a very subtle bevel on the edge of that shaft aswell. Its very rare to find a true sharp edge like that in the world.