Lightwave Community at SimplyLightwave - View Single Post - grass type bending problem, refraction i think

chrispo1 · 21-08-2003, 03:26 PM

Hi, Im doing a print job based on a bottled drink here in the UK, I've had horrible times rendering and texturing. I started off with << FIRST OFF TEST RENDER >> but the customer did not like it so I changed it to look a bit like a smirnoff ice bottle. Its still real hard to render the refraction at a big size (print needs to be to scale at 300dpi or 300 pixels per inch) so, is there a way to render faster? I've tried turning off reflections and then pshoping them in last. Here is my latest. << LATEST >> its a bit more evil. The customer likes it but wants it more evil....

Any ideas give me a bell.

21-08-2003, 03:26 PM	#9
chrispo1 Registered Member Join Date: Aug 2003 Location: Belfast NI Posts: 8	Hi, Im doing a print job based on a bottled drink here in the UK, I've had horrible times rendering and texturing. I started off with << FIRST OFF TEST RENDER >> but the customer did not like it so I changed it to look a bit like a smirnoff ice bottle. Its still real hard to render the refraction at a big size (print needs to be to scale at 300dpi or 300 pixels per inch) so, is there a way to render faster? I've tried turning off reflections and then pshoping them in last. Here is my latest. << LATEST >> its a bit more evil. The customer likes it but wants it more evil.... Any ideas give me a bell. __________________ If your going to read this you may as well visit my site... http://www.expertprintni.com