Lightwave Community at SimplyLightwave - View Single Post

Tabu · 24-09-2003, 10:16 PM

Im not that good at this.. but i would say that there is some points that are not attached...

Also in surface editor, remember to check the smooth surface...

As said before... thake the supatch of, select all points, press 'm' to merge, and merge !!

24-09-2003, 10:16 PM	#9
Tabu Registered Member Join Date: Jun 2003 Location: Denmark, Cobenhagen Posts: 44	Im not that good at this.. but i would say that there is some points that are not attached... Also in surface editor, remember to check the smooth surface... As said before... thake the supatch of, select all points, press 'm' to merge, and merge !!