Lightwave Community at SimplyLightwave - View Single Post

Mark · 03-10-2003, 04:48 PM

There are a number of config files that you'll need to remove. They can all be found in your home drectory on the PC (not sure about the Mac version - don't have one to check).

Basically you should have:
lw3.cfg - Layout config file.
lwext3.cfg - Plugins config file.
lwhub.cfg - Hub configuration.
lwm3.cfg - Modeller configuration.

Deleting all of these will set the application back to default settings (remember, you'll need to re-install all your plugins if you remove the lwext3.cfg file)

Also, if you have any plugins that save their settings in external files (such as the spreadsheet manager, motion mixer, treegen, etc...) then you'll also need to remove their config files to reset them too.

03-10-2003, 04:48 PM	#3
Mark Super Moderator Join Date: Jan 2003 Location: Sunbury, UK Posts: 2,339	There are a number of config files that you'll need to remove. They can all be found in your home drectory on the PC (not sure about the Mac version - don't have one to check). Basically you should have: lw3.cfg - Layout config file. lwext3.cfg - Plugins config file. lwhub.cfg - Hub configuration. lwm3.cfg - Modeller configuration. Deleting all of these will set the application back to default settings (remember, you'll need to re-install all your plugins if you remove the lwext3.cfg file) Also, if you have any plugins that save their settings in external files (such as the spreadsheet manager, motion mixer, treegen, etc...) then you'll also need to remove their config files to reset them too.