View Single Post
Old 18-06-2016, 01:28 PM   #1
Registered Member
Join Date: Apr 2016
Posts: 3
Default Error: Coincident points

Hello, I'm doing the training on the Little Robot Basic Modeling. I'm currently on the fifth video where they are constructing the hands and have come across a problem. When it comes to the part where I have to connect the two parts that will form the hand with the BRIDGE tool, I continually get a pop up information box which reads:

"Could not find matching points to bridge. Make sure there are no coincident points. Falling back to failsafe method."

When I click on "OK" an error box appears which states:

"Error code 2905 has occurred. Internal fault of unknown origin. Try operation again or restart Modeler"

I've done both and continue to get the same error messages.

I'm using LW 2015.3 on Mac 64.

Any help would be appreciated.

J. Lebron

Last edited by powerdot; 18-06-2016 at 01:42 PM. Reason: Change title
powerdot is offline   Reply With Quote