View Single Post
Old 10-09-2006, 12:31 AM   #3
Registered Member
Join Date: Sep 2006
Posts: 8
Default how to enable IK(IK WAS DISABLED BY THIS TOOL)

thank u towerfan...for spending time to look at my problem...when i tried to follow ur steps..i couldnt able to complete JOINTMOVE operation... when i finished moving the joint a msg box pops up n says "IK WAS DISABLED BY THIS TOOL" ..n after tht nothin works only the nulls r rotating how to enable IK again...thanks
lwfreak is offline   Reply With Quote