trying to remove triangle
 

this modeling stuff has a lot to do with matematics and regular triangles and squares

http://www.firedragon.com/~lwg3d/upl.../08-309174.jpg

i highlighted the triangle and i can't figure out an effective way of removing it or converting it to a square

is there any way besides cutting down the length of the roof and letting the spline carry right back in the same direction?

Its often difficult to get rid of all tri's in a complex mesh like a car, is it causing any problems?

hope this makes sense to you.

thats exactly what i was trying to do
my brain was working too hard and the most obvious solution i didn't find
thanx