Use of the clone tool
 

I am currently working through Dan Ablans' Inside Lightwave 7 book and have reached a point where i am modelling the hull of a rowing boat. After drawing my first spline i am then instructed to select the clone tool and enter the offset values as pictured in the book..This should obviously create copies of my original spline in the positions dictated by the offset ( 4 copies selected)..I enter all the required parameters and hit "enter" and according to the book i will see my cloned splines....I hit "enter" and nothing happens ??? Am i missing something..

Cheers
D

Its OK now i sorted it........
It was working just fine, only problem being my offset was in metres and the books was in mm.....
Thats what you get for trying to do sensible stuff while full of whiskey !!!!!!!
Buuuuurp!!!!!

:)