03-04-2004, 11:56 PM
|
#1 |
|
Registered Member
Join Date: Mar 2004
Posts: 5
|
Use of the clone tool
I am currently working through Dan Ablans' Inside Lightwave 7 book and have reached a point where i am modelling the hull of a rowing boat. After drawing my first spline i am then instructed to select the clone tool and enter the offset values as pictured in the book..This should obviously create copies of my original spline in the positions dictated by the offset ( 4 copies selected)..I enter all the required parameters and hit "enter" and according to the book i will see my cloned splines....I hit "enter" and nothing happens ??? Am i missing something..
Cheers D |
|
|
|
04-04-2004, 12:42 AM
|
#2 |
|
Registered Member
Join Date: Mar 2004
Posts: 5
|
Its OK now i sorted it........
It was working just fine, only problem being my offset was in metres and the books was in mm..... Thats what you get for trying to do sensible stuff while full of whiskey !!!!!!! Buuuuurp!!!!! |
|
|
|
|
04-04-2004, 07:15 AM
|
#3 |
|
Tutorial Clown
Join Date: Dec 2002
Posts: 817
|
__________________
Don't ever argue with idiots. They drag you down to their level and beat you with experience. |
|
|
|
 |
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cuting tool like Knife-tool | aakashem | Modeling | 1 | 12-07-2007 02:14 AM |
| Rail Clone Problem | kennez | Modeling | 2 | 08-03-2004 11:18 PM |
| Rail Clone | prodigouz | Modeling | 1 | 03-06-2003 10:52 PM |
| pen tool | mikefran | LightWave Basics | 11 | 09-04-2003 06:41 PM |
|
