11-09-2006, 04:45 PM
|
#1 |
|
Registered Member
Join Date: Sep 2006
Posts: 8
|
IK BOOST- point to target - PROBS
i downloaded a tutorial on IK BOOSTER from the following link
http://www.ikboost.com/upload/upload...terLink_03.rar i have some problem when i set "point to target" option(17:15) ...the crank is not following the cylinder....rather its rotating with its parent gear only..i followed the same steps in the tut.....i tried my best but i cudnt spot where i did wrong...plz check my obj n scene file...and do advice me a remedy .. thank u |
|
|
|
11-09-2006, 04:56 PM
|
#2 |
|
Registered Member
Join Date: Sep 2006
Posts: 8
|
change of tut link !!
|
|
|
|
 |
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to get point? | marvel99 | Site Questions & Suggestions | 4 | 18-11-2022 08:06 AM |
| POINT | khalid72 | Site Questions & Suggestions | 2 | 09-04-2005 10:38 PM |
| Point selection | bjørn | Members Lounge | 2 | 15-03-2005 06:32 PM |
| Video Capturing Probs | K Dawg | Site Questions & Suggestions | 1 | 23-01-2004 10:42 PM |
| Snapping to point? | danielh68 | Modeling | 6 | 25-07-2003 11:00 PM |
|
