01-06-2004, 03:07 AM
|
#1 |
|
Registered Member
Join Date: Aug 2003
Posts: 6
|
jail key model
Need help in modeling an old key used to open dungeon jail cells from the ancient period. You know the one, has a ring on one end and two thingabobs at the other end that goes into the lock. Anyone have an idea where I can get a mesh or tut on this?
|
|
|
|
01-06-2004, 04:50 AM
|
#2 |
|
Full Access Member
Join Date: Jan 2003
Posts: 174
|
Break the key down into primative shapes.
The ring at the top is a torrid. The "thingabobs" are box-like. The shaft is a cylinder. I'd suggest starting with a cylinder. Make a couple knife cuts and extrude a box-like shape for the pins. Make a torrid and connect it to the cylinder. Subpatch it and bandsaw the edges to sharpen it up. Give me your email address if you don't quite understand. I'll send you a real quick model so you can check it out. |
|
|
|
 |
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| low rez model | quaoar | Finished Work | 6 | 20-06-2006 05:04 PM |
| First model | drummerzoid | W.I.P | 2 | 08-03-2005 07:48 AM |
| Gir and Pig Model | r0ssr0ss | W.I.P | 3 | 23-04-2004 08:44 PM |
| My very first model | icezAz | W.I.P | 5 | 15-05-2003 07:29 AM |
| My Very First Model | Nail | Finished Work | 5 | 09-03-2003 09:10 AM |
|
