28-08-2005, 11:18 PM
|
#1 |
|
Full Access Member
Join Date: Apr 2003
Location: US
Posts: 207
|
Very basic question
I’m trying use Boolean or Drill to cut a box form on this material, which I can do without problem, but I will need round corners and not straight.
What should I do to achieve this effect?
__________________
Claudio www.kakosvideo.com |
|
|
|
28-08-2005, 11:24 PM
|
#2 |
|
Full Access Member
Join Date: May 2004
Location: USA, Texas
Posts: 110
|
you should try and freeze it then make the cut
|
|
|
|
|
29-08-2005, 07:45 AM
|
#3 |
|
Registered Member
Join Date: Jun 2005
Posts: 86
|
Or use rounder on the points where you want the area rounded, just the cutting sides.
~~CM! |
|
|
|
|
30-08-2005, 12:58 PM
|
#4 |
|
Registered Member
Join Date: Jun 2004
Posts: 21
|
I was just looking through the manual yesterday and read about rounder.
it's on page 1095 on the pdf manual. seems to be a useful tool. |
|
|
|
|
30-08-2005, 12:58 PM
|
#5 |
|
Registered Member
Join Date: Jun 2004
Posts: 21
|
I was just looking through the manual yesterday and read about rounder.
it's on page 1095 on the pdf manual. seems to be a useful tool. |
|
|
|
 |
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| A Basic Rendering Question | MBStudios | Rendering, Lighting, Texturing and Effects | 5 | 24-11-2004 08:09 PM |
| Need Halp that is NOT Basic | Sarkaz | LightWave Basics | 3 | 31-08-2004 04:44 AM |
| probably a basic question | Pheminyne | LightWave Basics | 31 | 19-10-2003 12:30 PM |
|
