18-07-2004, 10:31 PM
|
#1 |
|
Full Access Member
Join Date: Apr 2004
Location: Espoo, Finland
Posts: 121
|
lost polygons
Hi,
After Lay Out crash on "save as" in modeler there were many holes in mesh at reload. When I tried creating polys on holes I get message not enough points selected, even there is. This has happened me several times. Any sollutions? |
|
|
|
18-07-2004, 10:33 PM
|
#2 |
|
Full Access Member
Join Date: Apr 2004
Location: Espoo, Finland
Posts: 121
|
forgot this image.
|
|
|
|
|
19-07-2004, 12:01 AM
|
#3 |
|
Full Access Member
Join Date: Apr 2004
Location: Espoo, Finland
Posts: 121
|
Ok,
I used Pen Tool and welded created poly to mesh. After one poly was added make poly tool was functional again, I have no explanation, maybe I was on wrong layer or something.
__________________
-Raise taxes- |
|
|
|
|
19-07-2004, 07:20 AM
|
#4 |
|
Moderator
Join Date: Jan 2003
Posts: 1,702
|
I sometimes get this - I usually make sure that I'm only working in one layer and if that fails, restart lightwave and try again.
|
|
|
|
 |
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| un-rendered polygons? | ddrifmeyer84 | Rendering, Lighting, Texturing and Effects | 5 | 24-10-2005 11:38 AM |
| Problem with double polygons!! | Krull | Modeling | 3 | 14-04-2005 07:49 AM |
| Tool to extrude side of polygons? | shi4 | Modeling | 3 | 11-02-2004 09:58 PM |
| Missing polygons | mikefran | LightWave Basics | 5 | 08-04-2003 05:37 AM |
| Does LW render polygons u can see | koots | Rendering, Lighting, Texturing and Effects | 1 | 25-03-2003 08:54 PM |
| Thread Tools | |
|
