05-01-2009, 10:14 PM
|
#1 |
|
Registered Member
Join Date: Feb 2005
Location: Sheffield
Posts: 45
|
Cut tool problems
Hi there, still on the Mech tutorial, got to a section where the Cut tool is used, i've never really used this before, seems straight forward enough on the tut, but when I try the same it messes up, hard to describe by text so i'll post screenshots...
As you can see I input the same figures, but come out with very different results... Help please? |
|
|
|
05-01-2009, 10:16 PM
|
#2 |
|
Registered Member
Join Date: Feb 2005
Location: Sheffield
Posts: 45
|
2
|
|
|
|
|
01-02-2009, 11:40 PM
|
#3 |
|
Super Moderator
Join Date: May 2003
Posts: 232
|
hmm.. that is odd. I'm wondering if you have some extra edges there. Double check in the polygon statistics panel for 2pt polys.
|
|
|
|
 |
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cuting tool like Knife-tool | aakashem | Modeling | 1 | 12-07-2007 02:14 AM |
| selection tool | Techi | Modeling | 5 | 28-04-2004 06:45 AM |
| Use of the clone tool | Simmo1111 | Modeling | 2 | 04-04-2004 07:15 AM |
| pen tool | mikefran | LightWave Basics | 11 | 09-04-2003 06:41 PM |
|
