09-02-2004, 07:03 AM
|
#1 |
|
Full Access Member
Join Date: Apr 2003
Posts: 49
|
trying to remove triangle
this modeling stuff has a lot to do with matematics and regular triangles and squares
 i highlighted the triangle and i can't figure out an effective way of removing it or converting it to a square is there any way besides cutting down the length of the roof and letting the spline carry right back in the same direction? |
|
|
|
09-02-2004, 08:20 AM
|
#2 |
|
Super Moderator
Join Date: Jan 2003
Location: Sweden
Posts: 1,182
|
Its often difficult to get rid of all tri's in a complex mesh like a car, is it causing any problems?
hope this makes sense to you.
__________________
http://www.digitalmagic.se mattias@digitalmagic.se icq:1687432 msn: eternal_e@hotmail.com |
|
|
|
|
10-02-2004, 07:13 AM
|
#3 |
|
Full Access Member
Join Date: Apr 2003
Posts: 49
|
thats exactly what i was trying to do
my brain was working too hard and the most obvious solution i didn't find thanx |
|
|
|
 |
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Remove an upload | liquidknight | Site Questions & Suggestions | 1 | 10-08-2005 08:35 AM |
| Thread Tools | |
|
